2 Connect Homes Coax Splicer (Apprentice) henderson, TN · Remote · Full time

Apply for Coax Splicer (Apprentice)

Essential Duties:

• Read and interpret work orders, specifications, engineering drawings, and/or cut sheets to determine work to be done in a sequence of tasks.
• Repair or splice in a new line as needed to complete the testing and certification of the project.
• Place and install the required coax cable when necessary to complete the assignment(s).
• Install all passive and active devices (amplifiers, taps, splits), pedestals, vaults, and coax splice cases required to house CATV equipment per customer requirements.
• Test RF lines for the balanced signal between points-continuity and fault.
• Read and understand site plans, maps, diagrams, designs, and prints needed to support the project(s).
• Pull Coax through existing duct package, pull cable through conduit either manually, blowing, or mechanically, and splice and activate underground and aerial lines.
• Splice in node splits to reduce capacity
• Utilize RF Meters and TDR accurately
• Ability to safely utilize bucket trucks or climb utility poles to place cables on poles per system design.
• Close a project by completing production sheets, verifying proper levels after activation, and adjusting and troubleshooting as necessary.
• Ensure that all work considers the safety of the customer and public and compliance with all governmental orders,
• Ensure proper safety techniques and incident reporting procedures are followed
• Communicating with Local MSO Employees as a Representative of 2 Connect Homes.
• Other duties as required.

Physical Demands:

The physical demands described here are representative of those that must be met by an employee to successfully perform the essential duties of this job.

• Frequent walking, standing, and sitting within the work area.
• Must be able to lift/push/pull/carry up to 75 pounds
• Ability to effectively communicate with employees, management, peers, etc.
• Must be able to work in various weather conditions (hot, cold, wet, and dry)
• Ability to work in a confined space and at high elevations (poles, hydraulic lift buckets, ladders)
• Up to 50% local travel is required to a variety of worksites (planned in advance)
• Must be able to work in a loud, noise-filled environment out in the field